Set Gefest GFS ZK 30 (M) President 1020/60 Talcomagnesite
GFS-ЗК 30 - a stove with a reinforced heater of greater mass, with a single recess inside the furnace for additional laying of a cast-iron charge. Heat-removing spikes, on the side of burning flame, significantly increase the area of contact between the fire and the heater and accelerate the transfer of heat, and also contribute to better afterburning by mixing the flow of flame and air coming from the air vent. These improvements significantly increase the steam generation capacity of the oven and produce more steam with continuous water supply. The heater of GFS-ZK stoves is non-fillable.
The kit includes:
- furnace GFS-ZK 30 (M)
- box
- door 450
- facing President 1020/60 Talcomagnesite
- ash drawer (structural steel)
- sealant "Titan" up to 1500С
- warranty passport (operating manual)
Russian sauna
Hephaestus 3K stove with a unique direct heating stove for producing light, finely dispersed steam, which is necessary for the Russian bath regime. Thanks to its innovative design, the oven is guaranteed to come on in 60 minutes.
Patented heater
The unique stove with a thickness of 45 mm provides unsurpassed reliability and high heat capacity, 120 heat-removing pins along its entire surface, allow the stove to heat up to 700 degrees in 60 minutes and retain heat for a long time.
Pyrolysis gas afterburner system
In the second chamber of the furnace, the pyrolysis gases are afterburned with the help of the air flow, thereby increasing the combustion temperature, which increases the efficiency of the furnace up to 90 percent.
Convection ribs
Increases the heat transfer surface area by 110 percent, which ensures rapid heating of the steam room.
System «Clean glass»
Due to the directional convection of the air flow, the glass is cleaned, soot and soot does not settle on its surface, the glass remains completely clean and transparent for a long time.
Unique heat release pins
Pyramidal spikes located inside the firebox on the side walls contribute to the efficient burning of firewood and increase the heat transfer area by 80%, which allows the stove to enter the mode more dynamically.
Have questions? Need help or advice?
Fill out the form, we will contact you shortly.