Avangard 24 (М) in a round grid
Avangard 24 is a new concept of a cast-iron heat-accumulating sauna stove with direct heating of the charge.
The body is modular, assembly takes place from the bottom up, the modules are connected according to the tongue-and-groove system.
Mass of the steam evaporator in the Avangrad 24 oven – 56 kg and it is heated by direct contact with the flame. The steam evaporator has 2 surfaces with an increased working area – from below there is heating by fire, and from above water is given for steam. To increase the evaporation area and heat the first layers of stones, high spikes are cast on the stove.
A flame divider is installed under the stove on 3 stops, it divides the flame into 3 streams and directs first to the side parts of the body for intensive heating of the walls and convection heating of air in the steam room. For this, convection ribs are located on the outer surfaces. Then the flame passes through the ledges to the exit to the chimney, heating the stove.
The heater allows you to install various Hephaestus starter modules together with the slide block.
- sauna stove Avangard 24
- starting nozzle
- stainless steel ash box steel
- Round grid
- sealant "Titan" up to 1500С-1 pc.
- warranty certificate (instruction manual)
Hephaestus 3K stove with a unique direct heating stove for producing light, finely dispersed steam, which is necessary for the Russian bath regime. Thanks to its innovative design, the oven is guaranteed to come on in 60 minutes.
The unique stove with a thickness of 45 mm provides unsurpassed reliability and high heat capacity, 120 heat-removing pins along its entire surface, allow the stove to heat up to 700 degrees in 60 minutes and retain heat for a long time.
Pyrolysis gas afterburner system
In the second chamber of the furnace, the pyrolysis gases are afterburned with the help of the air flow, thereby increasing the combustion temperature, which increases the efficiency of the furnace up to 90 percent.
Increases the heat transfer surface area by 110 percent, which ensures rapid heating of the steam room.
System «Clean glass»
Due to the directional convection of the air flow, the glass is cleaned, soot and soot does not settle on its surface, the glass remains completely clean and transparent for a long time.
Unique heat release pins
Pyramidal spikes located inside the firebox on the side walls contribute to the efficient burning of firewood and increase the heat transfer area by 80%, which allows the stove to enter the mode more dynamically.
Have questions? Need help or advice?
Fill out the form, we will contact you shortly.